Replacing the side grilles on your BMW E46 M3 is relatively ‘tricky’ but not difficult, you just have to know how to do it.
Continue reading →

Take a look at your package, you will have two intertwined pieces of plastic. Lift up one side, you will see that it is really two pieces connected into one via clips that slide together and ‘snap’ at the end, holding the two parts together there.

Continue reading →

Installing our upgraded gauge rings to give your car the M3 or M5 look is a somewhat difficult install, pulling the gauge cluster out is the easy part, but separating the front from the back is the tough part. Continue reading →

Here is the best DIY guide we could find online for installing ours (or any) LED Interior light kits for the BMW E46 3 series sedan and coupe. The convertible is the same, just a few less steps. You really don’t /need/ this DIY as you truly can just look at each interior light and pop the cap off and switch the halogen to LED, but incase you have any issues here you go! (This DIY is written by the amazing E46fanatics member ‘sillieidiot’ and was only modified slightly to be true to our plug and play option. You can read the original DIY thread: http://forum.e46fanatics.com/showthread.php?t=640683)

<

Continue reading →

Removal of these two pieces sounds easy enough, but you’re probably here because you’re struggling a little bit… Continue reading →

Replacing your pitted and faded headlight lens is a simple task and very, very, worth it in the long run. Out of all the replacement or removal guides we found, obviously ours is the best, even taking pages right out of BMW’s repair manual and bentley’s guide. If you need any more assistance replacing and removing your headlight lens let us know!

We found this incredible video from Bentley showing you how to remove your headlight assembly from your car and the seals and clips required to replace the lens. Continue reading →